The growth condition of thin heavily Mg-doped GaN capping layer and its effect on ohmic contact formation of p-type GaN were investigated. It is confirmed that the excessive Mg doping can effectively enhance the Ni/Au contact to p-GaN after annealing at 550 °C. When the flow rate ratio between Mg and Ga gas sources is 6.4% and the layer width is 25 nm, the capping layer grown at 850 °C exhibits th...
We report the generation of microdischarges in devices composed of microcrystalline diamond. Discharges were generated in device structures with microhollow cathode discharge geometries. One structure consisted of an insulating diamond wafer coated with boron-doped diamond layers on both sides. A second structure consisted of an insulating diamond wafer coated with metal layers on both sides. In e...
We report the Au-assisted chemical beam epitaxy growth of defect-free zincblende InSb nanowires. The grown InSb segments are the upper sections of InAs/InSb heterostructures on InAs(111)B substrates. We show, through HRTEM analysis, that zincblende InSb can be grown without any crystal defects such as stacking faults or twinning planes. Strain-map analysis demonstrates that the InSb segment is nea...
It is still a great challenge for semiconductor based-devices to obtain a large magnetoresistance (MR) effect under a low magnetic field at room temperature. In this paper, the photoinduced MR effects under different intensities of illumination at room temperature are investigated in a semi-insulating gallium arsenide (SI-GaAs)-based Ag/SI–GaAs/Ag device. The device is subjected to the irradiation...
The process to decrease the dislocation density in 3-inch Fe-doped InP wafers is described. The crystal growth process is a conventional liquid encapsulated Czochralsky (LEC) but thermal shields have been added in order to decrease the thermal gradient in the growing crystal. The shape of these shields has been optimized with the help of numerical simulations of heat transfer and thermomechanical ...
This paper proposes a new three-dimensional (3D) photolithography technology for a high-resolution micropatterning process on a fiber substrate. A brief review on the lithography technology of the non-planar surface is also presented. The proposed technology mainly comprises the microfabrication of the 3D exposure module and the spray deposition of thin resist films on the fiber. The 3D exposure m...
The density and light-scattering intensity of oxygen precipitates in CZ silicon crystals are measured by IR light-scattering tomography. The numerical data clarified through the measurements are discussed in relation to the amount of precipitated oxygen. The results obtained here correspond well with the theoretical analysis that oxygen precipitates cause light to scatter. The information obtained...
Te-doped GaSb single crystals are studied by measuring Hall effect, infrared (IR) transmission and photoluminescence (PL) spectra. It is found that the n-type GaSb with IR transmittance can be obtained as high as 60% by the critical control of the Te-doping concentration and electrical compensation. The concentration of the native acceptor-associated defects is apparently low in the Te-doped GaSb ...
Contact Information
luna@powerwaywafer.compowerwaymaterial@gmail.com 
+86-592-5601 404
